Knowledgebase : Automotive solutions (In-car audio) > iGateway
In case of CAN BAP based systems the Media option is disabled (most cases) therefore it has to be coded before or after the Gateway installation. The procedure is not difficult (takes 10 minutes approx.), the vehicle needs to be taken to the VW service an...
The iGateway uses the same harness as the Gateway Pro BT which has built-in phone function as well. On that cable there is a separate 4 pin Molex cable. These wires on the 4 pin Molex are the phone audios and the phone mute. In the first case the 4 pin M...
Firmware update procedure on iGateway is much more complicated compare to other devices because of the missing USB option, which means iPod can be used for that only. Please note: iPod touch and iPhone cannot be used for update How to update: * Dele...
This usually happens if there is a problem with the iPod / iPhone or Dock cable. Also it can happened after an iOS update. Before replacing anything, you need to try the following: * Make sure that is has music on it * Reboot the Apple device (if th...
Sometimes on BMW it may be possible that there is no sound when Navigation / phone is used. This might happen because the 10 pin Molex (white) connector (Dension piece) not all wires are present for the sound, therefore it cannot be transferred to the spe...
This problem could appear on 2 specific cases * The car has DSP * The CD-Changer plug has been connected on a wrong way on BM1 compatibility (17 PIN or it is also known as Round PIN connector) DSP: If the car has DSP, the application is not compati...
On BMW, it happens quite often that they forget to disconnect the original CD-Changer properly. Please note: It is necessary to disconnect all cables physically from the CD-Changer (2 separate wires), otherwise you will experience issues like: * Volum...
The iGateway is designed for vehicles where text display is available. It does not work properly in non-text mode, except on BMW where it can be used in that mode too. The most important things what you need to know are: * Text mode is set ON by defau...
The iGateway has no USB port, therefore you need to use an iPod to change the volume output of the iGateway. You need to visit our homepage, especially the download section where the volume configuration files are located. Download them and then follow th...
The Gateway can work with all iPod and iPhone models. Please note: you need to use specific Dension accessories to connect them to the Gateway: * 30-pin iPod Dock Cable (IPO5DC9 * Lighting to 30-pin adapter for Gateway (LIA1GW0) iPad: iPad is onl...